Lots of jobs done, slowly ticking them off the to do list.
Clutch cable on and working. Found it on eBay from a Westfield and its perfect. We were a bit worried at first because the engine wouldn't turn but we realised we had our new pivot screwed in too far and was catching on the clutch so we backed it off a bit and its works a treat.
Cam cover on we got it powdered a while ago but didnt want to put it on because we didnt want it to get damaged.
Fuel pipes run down the tunnel we ran two as we need a return. Left plenty at each end so we have room to play when we get the next bits sorted. We ran out of the metal p clips after the first pipe so we had to use some plastic ones on the second one which were a right pain in the arse because we had to use a washer and hold it whilst riviting it in a really small awkward space. we got there in the end though and really chuffed with the results.
Ran the rear end wiring loom too ran plenty of wires just in case we forgot about anything.
Handbrake cable cut and made to the right length hooked and fastened in place all working well.
We were happy that we wouldn't need to rivet anything else inside the tunnel so we put the interior tunnel panels on, they look really good :)
Last job of the day put the starter motor on.
No comments:
Post a Comment