Had a productive weekend, got a few bits finished off on the chassis. We have decided to paint the chassis rather than powder coating because its cheaper and if we need to change or add anything to the chassis later on we can just re-paint it.
We had a few radiators kicking around but realised they were no good for a few reasons so i found a nice new clio one on the bay and the fan is from a saxo that we had already. Made the radiator mounts from some rectangle tube, 25mm tube and plate. It was a bit of a pain to get it in the right place and hold it to weld also we have slightly offset it to allow easier access for the pipes.
It needs trimming and tidying up a bit but it works great!
We have put some extra supports in for the front top wishbones as they were overhanging a bit too much. We will have to see it the shock and coil spring will foul or not so fingers crossed.
Headlight mounts were not too bad to make and a bit of guess work with the length so we will have to check this when the body kit is on to make sure Mr IVA will be happy with the distance to the widest part of the finished car.
We had these cut when we got the chassis plates made for some reason we have 8 only need 4. They are for the flexi brake lines to hold the joint.
The book said to put the rear ones on the back face of RS14 but we decided to put them on the top seemed to make more sense as it should be easier to run the copper brake pipes round to them.
No comments:
Post a Comment