Fuel Filler

Was a bit nerve racking drilling a great big hole in the back panel but we managed to get it spot on luckily. We thought lining the holes top and bottom would make the cap sit straight but we should of double checked really as it is a bit wonky but its on and doesn't look too bad.

Exhaust On

Finally got the exhaust on! its blowing a bit but fits a treat and sounds ace! Dads going to weld it all up fully and make a gasket for the flange. Need to fit some heat protection around the hole in the bodywork and wrap the exhaust too. Also need to weld in a nut for the lambda sensor to screw into

Got a couple of the bonnet catches on they work really well and pull the bonnet down nice and tight. Going to put 2 on the front as well so 4 in total.

Radiator Reposition

We quickly realised the nose wasn't going to fit over the radiator where it was so dad chopped off the bracket we made then with some faffing figured out where it could sit with the nose on and made a new bracket. Looks snug but fits ok now. Also got the mesh on the nose cone now which is hard to photograph but looks ace on real life.

Charlie called shotgun for the first drive lol.